Clamp-N-Guide

A Straightedge and a Clamp All in One!
Let's start with a closer look
at the Router Adapter. Sure, you can press your router against a straightedge and rout a groove. But grain switchbacks and bit condition can fight against you, trying to pull the router away from the guide. The Clamp-N-Guide Router Adapter locks into the straightedge, keeping everything right on track and delivering flawless grooves, dadoes, rabbets and mortises. You can also add a pair of stops to limit the travel of the Router Adapter for mortises and stopped dadoes.
Most router adapters
that follow a guide rail have an annoying feature. They elevate the router base above the workpiece. Your router is either surfing half-way on top of the rail or it gets mounted to another "universal" base. Clamp-N-Guide keeps your router base where it belongs…flat on your work. The key is using the guide rod connection, a feature that's almost as old as routers themselves. Our track and rod system adjusts to any spacing between the rods and any thickness of base. New router or old, chances are the Clamp-N-Guide Router Adapter will fit.
However, you're not limited
to using the Clamp-N-Guide with the Router Adapter. Use it to keep your circular saw right on line, just like the fancy track saws…but without the fancy price tag. It's perfect for the first few cuts on a sheet of plywood to get the sections the right size to finish on your table saw.
And when your project is further along,
don't forget these are great assembly clamps, too. Slide the tailstock up to your work and grab the hand-sized hand grip to cinch it up. The clamping rod is knurled
(just like the back of the bar on a parallel jaw clamp)
giving the clamp clutches a firm grip.
We make the Clamp-N-Guide
in two sizes, 24" and 48" clamping capacity. The Router Adapter is available with 4 different guide rod sizes, 1/4", 5/16", 3/8" and 10mm. There's a chart in the image carousel that shows you the right sized guide rods for many popular routers and how to measure the holes in your router base if it's not on the list.
Like all Woodpeckers products,
the Clamp-N-Guides and the Router Adapters are precisely machined and carefully inspected in our Strongsville, Ohio, facility just south of Cleveland.
Router Compatibility
This list is not intended to be comprehensive! These are routers that we have specifically tested for compatibility and have listed their appropriate rod size for your convenience. If your router is not on this list, you can determine in a few minutes if the Clamp-N-Guide Router Adapter is compatible.
1. Does your router have holes in the base to accept a pair of guide rods?
2. Do the holes go completely through the base?
3. Will the holes fit one of these sizes: 1/4" (6mm), 5/16" (8mm), 3/8" (9.5mm) or 25/64" (10mm)?
If the answer to all three questions is YES, the Clamp-N-Guide Router Adapter will fit your router.
Measuring the hole size: The surest way to get the correct-sized guide rods is to measure the guide rods that came with your router. If your router has guide rod holes, but did not come with guide rods, you can measure the holes with drill bits. Find the drill bit that will freely pass through the guide rod holes without binding. Order the guide rod size that is equal to or slightly smaller than the drill bit.